Pulsafeeder L9807000-188 Hex Standoff - 0.31 Inch Hex, #10-32 Thread L9807000-188
Pulsafeeder Replacement Threaded Hex Standoff - #10-32 Hardware
Pulsafeeder L9807000-188 hex standoff with 0.31-inch hex dimension and #10-32 thread. Additional catalog dimensions: 0.62 x 1.31 inches.
The Pulsafeeder L9807000-188 is a hexagonal threaded standoff listed in Pulsafeeder replacement hardware catalogs.
The catalog description is STANDOFF .31HEX,10-32X.62X1.31. This identifies a 0.31-inch hex dimension, a #10-32 thread designation and additional published dimensional values.
Product Specifications
- Manufacturer: Pulsafeeder
- Part Number: L9807000-188
- Product Type: Hex Standoff
- Catalog Description: STANDOFF .31HEX,10-32X.62X1.31
- Hex Dimension: 0.31 Inch
- Thread Size: #10-32
- Additional Catalog Dimensions: 0.62 x 1.31 Inches
- Hex Dimension, Approximate: 7.87 mm
- Material: Not Independently Verified
- Thread End Configuration: Not Independently Verified
- Finish: Not Independently Verified
- Compatible Equipment: Verify Original Parts Documentation
Hex Standoff Function
Hex standoffs are mechanical hardware components used to maintain spacing or provide support between assembled parts.
The L9807000-188 should be used only where the manufacturer specifies this exact component or an approved equivalent.
0.31-Inch Hex Dimension
The catalog lists a 0.31-inch hex dimension.
This dimension should be checked against the original standoff and the equipment mounting requirements.
#10-32 Thread Specification
The part description identifies a #10-32 thread, corresponding to a No. 10 thread with 32 threads per inch.
The thread configuration and engagement requirements must be confirmed before installation.
Additional Dimensional Information
The published description includes the values 0.62 x 1.31 inches.
The exact meaning of these two dimensions has not been independently established from a manufacturer engineering drawing.
Do not substitute a component based only on these numbers without verifying its full dimensions.
Potential Applications
- Manufacturer-specified equipment hardware replacement
- Mechanical component spacing
- Support of compatible mounted assemblies
- Replacement of damaged threaded standoffs
- Original equipment hardware servicing
Inspection and Maintenance
Inspect the original component for stripped threads, bending, corrosion and wear.
Check associated fasteners and mounting points for damage.
Replace damaged hardware using the correct manufacturer specifications.
Installation Guidelines
Confirm that L9807000-188 is specified in the applicable equipment parts diagram.
Isolate the equipment and disconnect electrical power when required before performing maintenance.
Install the standoff in the correct mounting arrangement and follow the manufacturer tightening procedure.
Ordering Information
Order using the exact Pulsafeeder part number L9807000-188.
Verify the 0.31-inch hex dimension, #10-32 thread, additional catalog dimensions and required material before purchasing.
| Type | Accessories |
|---|
